It is recommended to use iPoll protocol for simple Point to Point network configuration.  Follow the steps to create a simple Point to Point link between Access Point iPoll and Station (iPoll):

Step 1.  Access Point iPoll 2 configuration: change device’s default IP address (can be static or dynamic), enable IP alias (Secondary IP) if necessary: 

tep 2.     Configure wireless  settings for Access Point iPoll 2:

– Select wireless mode: Access Point iPoll
– Set channel: Auto
all other settings should be left default:

– Define SSID
– Enable Security for secure traffic on link
all other settings should be left default:
Step 3.    Station iPoll 2 configuration: change device’s default IP address (can be static or dynamic), enable IP alias (Secondary IP) if necessary:

Step 4.     Configure wireless  settings for Station iPoll 2:

– Select wireless mode: Station (WDS/iPoll 2)
all other settings should be left default:
– Define SSID, or use “Scan” button to find iPoll 2 Access Points automatically
– Enable Security for secure traffic on link
all other settings should be left default:
Step 5.     It is highly recommended to change default administrator’s password for each unit:

Step 6. Verify the PTP link  connection.  Navigate to the Status | Information page. The Information page will display wireless information of the link.

The status page of the Access Point iPoll 2 must indicate that one peer (Station iPoll 2) is connected and information about connection must be displayed as follows:

Detailed information about connected peers stays at Status | Wireless page.

The status of the Station iPoll 2 must be displayed as Connected and progress bars indicating the quality of the connection must be displayed: