Menu
- Wireless Smart Battery Cameras
- Paradox Alarms
- Hikvision AX Pro
- CCTV
- UPS
- Support
- Paradox Alarms
- Basic Alarm Wiring
- How Do I Enter Programming Mode On MG5050 And SP6000?
- How Do I Enter Programming Mode On EVO192?
- How Do I Clear Combus Troubles On MG5050 And SP6000?
- How Do I Clear Combus Troubles On EVO192?
- How Do I Assign A Remote Control To The MG 5050 And SP 6000 Control Panel?
- How Do I Assign A Remote Control To The EVO192 Control Panel ?
- How Do I Delete A Remote Control On MG5050 And SP6000?
- How do I Add and Program a Wireless Zone on MG5050 or SP6000 ?
- How Do I View A Wireless Transmitter’s Signal Strength On MG5050?
- How Do I View A Wireless Transmitter’s Signal Strength and Battery Life On RTX3?
- How do I Wire a Keyswitch?
- How Do I Wire a PGM?
- How to connect a DCT10 to your Electric Fence
- What is ParadoxMyHome?
- How Do I Change Chimes On My TM50?
- What Firmware do I use for my TM50 Keypad and MG5050 Alarm Panel?
- How do I setup Insite Gold Mobile App?
- How Do I Setup My IP150 Module?
- How Do I setup the iParadox Android App?
- How Do I setup the iParadox iPhone App?
- How Do I Reset My IP150 Module?
- How do I Set the Time and Date on MG5050 or SP6000?
- Calculating Power Requirements
- Wireless Networking
- Software and Manuals
- General
- Hikvision
- What Ports do I forward for Hivision Cameras, DVR and NVR
- 3 Easy Steps to Protect IP Cameras From Hackers
- What is the default user name and password for Hikvision equipment?
- Typical Angle of View for Hikvision Turbo HD Cameras
- How to add a device in iVMS-4500
- How to set up push notifications on iVMS-4500
- Provision-ISR
- Paradox Alarms
1. Press [ENTER].
2. Enter your [INSTALLER CODE] (default: 000000) or [MAINTENANCE CODE] (no default).(With LED Keypad: [ARM] and [STAY] lights flash)
3. Enter 3-digit [SECTION] you wish to program. (With LED Keypad: [ARM] and [STAY] lights are ON)